Kompernass KH 2265 - Manual (Page 9)

English • 9
7. Select a suitable location
for the mini hi-fi system
Place the mini hi-fi system and loudspeakers on a level, flat,
scratchproof, non-slip surface. Make sure that the surface is
made to support the weight of the mini hi-fi system/speakers.
† Danger!
Do not place the mini hi-fi system …
Ú in areas exposed to direct sunlight. Otherwise, the mini
hi-fi system could overheat and be damaged irreparably.
This could also cause a fire!
Ú in the immediate vicinity of heat sources such as ovens,
heaters and similar devices or vent openings of other
electrical devices. Otherwise, the mini hi-fi system could
be damaged irreparably. This could cause a fire!
Ú in dusty environments. Otherwise dust could collect in
the mini hi-fi system. If a large quantity of dust collects
in the mini hi-fi system, it could overheat and be dam-
aged irreparably. This could cause a fire!
Ú in damp environments. Otherwise moisture could seep
into the mini hi-fi system. This could cause danger of
electrical shock and fire!
Ú in the immediate vicinity of water, such as bath tubs or
swimming pools. Do not place any receptacles contain-
ing water (e.g. flower vases) on the mini hi-fi system. If
water enters the mini hi-fi system or it falls into water, it
could cause danger of electrical shock!
Do not place open flames (e.g. burning candles) on the mini
hi-fi system. This could cause a fire!
Do not cover the vent openings of the mini hi-fi system! Do not
place the mini hi-fi system on beds, blankets, etc. Otherwise,
the mini hi-fi system could overheat and be damaged irrepa-
rably! This could cause a fire! Make sure that the vent open-
ings are at least 10 cm from the nearest wall or large object.
™ Careful!
Do not place the mini hi-fi system in areas exposed to physi-
cal shock or constant vibrations. Physical shock and constant
vibrations could lead to malfunctions and long-term damage.
8. Preparing the mini hi-fi
system for use
8.1. Unpacking the components
Carefully remove all components from the packaging. Al-
ways hold components with both hands. Do not drop the
components! This could cause irreparable damage.
8.2. Preparing the remote
control unit for use
1 Open the battery compartment of the remote control unit.
2 Place two AAA/LR03/Micro batteries in the battery
compartment. These are not included in the delivery. In-
sert the batteries in the right direction (polarity +/-) as
shown on the battery compartment.
3 Close the battery compartment of the remote control unit.
| Warning!
Battery acid could leak out, especially if the batteries are old.
Therefore you should remove all batteries if you do not plan
to use the remote control unit for long periods of time. This
protects the remote control unit from battery acid leakage.
8.3. Connect the subwoofer to the main unit
Insert the subwoofer connector cable into the appropriate in-
put on the back of the subwoofer.
8.4. Connect the loudspeakers
to the main unit
1 Uncoil the loudspeaker connector cable to its full length.
2 The loudspeaker connector cables have to be connected
to the loudspeaker outputs on the back of the main unit.
Insert …
Ú the right loudspeaker connector cable in the red loud-
speaker output ”R”.
Ú the left loudspeaker connector cable in the white loud-
speaker output ”L”.
IB KH2265 EN IE.indb 9 09.10.2004 18:44:21 Uhr