6’ bubblemassage, Technical information, Required electrical service – Kohler Memoirs 6' Bubble Massage K-1418-GCR User Manual
Page 2: Product diagram
Technical Information
Fixture:* basin area
top area
weight
Bathing
well
48
″
(121.9 cm)
x 27
″
(68.6 cm)
60
″
(152.4 cm)
x 30
″
(76.2 cm)
150 lbs
(68 kg)
water depth
capacity
To
overflow
16
″
(40.6 cm)
94 gal.
(355.8 L)
* Approximate measurements for comparison only.
Blower
motor /
control:
Heater
Voltage
Frequency Amperage
1 Hp
300 W
220-240 V
50/60 Hz
3 A
Drop-in cut-out
70-1/2
″
(179.1 cm) x
40-1/2
″
(102.9 cm)
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI) or Earth-Leakage
Circuit-Breaker (ELCB):
Blower motor/control
220-240 V, 15 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
Floor support under bath must provide for a minimum of 1600
lbs. (725.7 kg).
Hot water supply should be 70% of capacity or greater.
Installations will vary.
If installing a rim mount faucet, make sure there is no
interference with drain overflow and circulating system before
drilling any holes. Consult local and national codes for
minimum air gap requirements if installing a spout on the
faucet deck.
This bath is designed for drop-in installation only. It is not
suited for use in a three wall alcove with an overhead shower.
A blower motor/control access panel is required.
42" (106.7 cm)
72" (182.9 cm)
K-1418-GCR
3" (7.6 cm)
1-1/2" O.D.
Blower Motor/Control Access
34" (86.4 cm) W x
15" (38.1 cm) H
20-1/8"
(51.1 cm)
22"
(55.9 cm)
5-1/4" (13.3 cm)
36" (91.4 cm)
11-3/4"
(29.8 cm)
No change in measurements with drain
shown. (K-7161-AF or K-7161M-AF)
1-1/16" (2.7 cm)
2-7/8" (7.3 cm)
3" (7.6 cm)
Product Diagram
MEMOIRS
®
6’ BUBBLEMASSAGE
TM
MEMOIRS
®
6’ BUBBLEMASSAGE
TM
BATH WITH AIRJETS
Page 2 of 2
1035475-4-
D