Kenwood KDC-MP336AX - Manual (Page 22)

22 | English
Connecting Wires to Terminals
ANT.
CONT
MUTE
P.CONT
FRONT L
FRONT R
REAR L
REAR R
– +
FRONT
Battery
Ground wire (Black) - (To car chassis)
FM/AM antenna input
Fuse (10A)
Wiring harness
(Accessory
1)
Ignition wire (Red)
Battery wire (Yellow)
ACC
Car fuse box
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
White/Black
White
Gray/Black
Gray
Green/Black
Green
Purple/Black
Purple
Ignition key switch
Car fuse box
(Main fuse)
Rear left output / Sub Woofer left output (White)
Rear right output / Sub Woofer right output (Red)
Front right output (Red)
(KDC-MP4036AX only)
Front left output (White)
(KDC-MP4036AX only)
To Kenwood disc changer/ External optional accessory
(KDC-MP4036AX only)
⁄
To connect these leads,
refer to the relevant
instruction manuals.
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
If no connections are made, do not let the wire come out from the tab.
Depending on what antenna you are
using, connect either to the control
terminal of the motor antenna, or to the
power terminal for the booster amplifier
of the film-type antenna.
Power control wire (Blue/White) When using the optional power amplifier,
connect to its power control terminal.
Connect to the terminal that is grounded
when either the telephone rings or
during conversation.
Motor antenna control wire (Blue)
TEL mute wire (Brown)