Essential setup, Video outputs – Kodak MDV 300 User Manual

Page 4

ESSENTIAL SETUP

Video outputs

I n STOP mode, press

button

setup m enu a ppears.

SETUP

2
3

Highlight "Interlace Out" icon, press
button, sub menu appears.

ENTER

Highlight “S-Video”, "YCbCr" o r “RGB” as desired
and press

button.

ENTER

The player is equipped with the following video output ports:

Press

button

to quit.

SETUP

DEFAULT

Composite video (CVBS), S-Video, Y Pb Pr, SCART

Y P b Pr

Interlaced scan output:
Progressive scan output:

The factory default video output
setting is S-Video (interlaced scan)

In this mode the active video output ports are:
Composite video (CVBS) and S-Video.

To change the video output setting, after the system
connection is completed (see "SYSTEM
CONNECTION"), follow these steps:

Once the video “Interlace Out” has been set using
this procedure, the active video output ports are as
shown in the table below:

For Progressive scan output

With no disc i n the player press the PROG SCAN button o n the remote control twice. Progressive scan
component signals will be output from the Y/Pb/Pr jacks, whatever the previous “Interlace Out” video setting.
The same procedure is used to switch back to interlace scan mode.

The composite video (CVBS) output
is active in all three video output
settings. Always connect the CVBS
signal to the TV if any problem is
experienced with obtaining a
picture.

When Progressive Scan has been
selected, no signal will be sent to
the CVBS, S-Video or SCART
outputs.

.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........
.........

Language Video

Audio 1 Audio2 Rating

TVScreen
TVSystem

InterlaceOut
FadeMode

4:3LetterBox

Auto

S-Video

Slow

S-Video

YCbCr

RGB

Press

button

highlight "Video" icon.

RIGHT

Press

button

, sub-menu appears.

ENTER

IMPORTANT NOTE

Video port ->

CVBS

S-Video

Y Pb Pr

RGB (SCART)

Interlace Out

S-Video

Y Cb Cr

RGB

Yes

N o

Yes