Kodak MDV 300 - Manual (Page 2)

SAFETY INFORMATION
TO REDUCE THE RISK OF FIRE AND ELECTRIC SHOCK, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.
IMPORTANT SAFEGUARDS
1.
2.
3.
4.
5.
6.
7.
8.
9.
Read and Follow Instructions- All the safety and operation instructions
should be read before the videoproduct is operated. Follow all
operating instructions.
Retain Instructions- The safety and operating instructions should b e
retained for future reference.
Heed all Warnings-Comply with all warnings on the video product and in
theoperating instructions.
Polarization- This video product is equipped with a polarized alternating
-current line plug . This plug will fit into the power outlet, try reversing
the p l u g . I f t h e plug still fails to fit, contact your electrician to replace
your obsolete outlet. To prevent electric shock, d o n o t use this polarized
plug with an extension cord, receptacle, or other outlet unless the
blades can be fully inserted without bladeexposure. If you need an
extension cord, use a polarized cord.
Power Sources- This video product should b e o p e r a t e d only from the
type o f p o w e r s o u r c e indicated on the marking label. If you are not sure
of the type of power supply to your home, consult your video dealer or
local power company. For video products intended to operate from
battery power, or other sources, refer to the operating instructions.
Overloading- Do not overload wall outlets or extension cords as this can
result in a risk of fire or electric shock. Overloaded AC outlets, extension
cords, frayed p o w e r cords, damaged o r c r a c k e d wire insulation, and
broken plugs aredangerous, They may result in a shock or fire hazard.
Periodically examine the cord, and if its appearance indicated damage
or deteriorated insulation, have it replaced by your service technician.
Power-Cord Protection- Power-supply cords should b e routed so that
they are not likely to bewalked on or pinched by items placed upon or
against them, paying particular attention to cords at plugs, convenience
receptacles, and the point where they exit from the video product.
Ventilation- Slots and openings in the case a r e p r o v i d e d for ventilation
to ensure reliable operation of the video product and to protect it from
overheating. Theseopenings must not the blocked or covered. The
openings should never be blocked by placing the video product on a
bed, sofa, rug, or heat register. This video product should n o t b e p l a c e d
in a built-in installation such as a book case or rack, unless proper
ventilation is provided or the video product manufacturer's instructions
have been followed.
Attachments- Do not use attachments unless recommended by the
video product manufacturer as they may cause hazards.
: To reduce the
risk of fire and electric shock, do
not remove the cover (or back) of
the unit. Refer s ervicing only t o qualified service personnel.
The lightning flash with arrowhead symbol, within anequilateral
triangle, is intended to alert the user to the presence of uninsulated
"dangerous voltage" within product's enclosure that may be of
sufficient magnitude to constitute a risk of electric shock.
The exclamation point within an equilateral triangle is intended to
alert the user to the presence of important operation and servicing
instructions in the literature accompanying the appliance.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO
NOT EXPOSE THISAPPLIANCE TO RAIN OR MOISTURE.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
In addition to the careful attentiondevoted to quality standards
in the manufacture of your video product, safety is a major factor
in the design of every instrument. H owever, safety is your
responsibility, too. This sheet lists important information that will
help to assure your enjoyment and proper use o f the video
product a n d accessory equipment. Please read them carefully
before operation and u sing your video product.
Installation
Water and Moisture- do not use this video product near water for example,
near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement,
or near a swimming pool and the like. Caution: Maintain electrical safety.
Powerline operated equipment or accessories connected to this unit should
bear safety certification mark on the accessory itself and should not be
modified so as to defeat the safety features. This will help avoid any danger
and should not b e m o d i f i e d so a s t o d e f e a t t h e s a f e t y features. This will help
avoid any potential hazard from electrical shock or fire. If in doubt, contact
qualified service personnel.
Accessories- Do not place this video product o n a n u n s t a b l e c a r t , stand,
tripod, bracket, or table. The video product may fall, causing serious injury
to a child or adult as well as serious damage to the video product. Use this
video product only with a cart, stand, tripod, bracket,ortablerecommended
by the manufacturer's or sold with the video product.Any mounting of the
product should follow themanufacturer's instructions and use of a mounting
accessory recommended by themanufacturer.
Avideo product and cart combination should be moved with care. Quick
stops, excessive force, a n d u n e v e n surfaces may cause the video product
and cart combination to overturn.
Outdoor Antenna Grounding- If an outside antenna o r c a b l e s y s t e m is
connected to the videoproduct, b e s u r e the antenna o r c a b l e s y s t e m is
grounded so as to provide someprotection against voltage surges and
built-up static charges. Section 810 of the National Electrical Code,
ANSI/NFPA No.70-1984 (Section 5 4 o f C a n a d i a n Electrical Code, Part1)
provides information with respect t o p r o p e r g r o u n d i n g of the mast and
supporting structure, grounding of the lead-in wire to anante nna-discharge
unit, connection to grounding electrodes, and requirements for the
grounding electrode.
Power Lines-An outside antenna system should n o t b e l o c a t e d i n t h e
vicinity of overhead power lines, other electric light or power circuits, or
where it can fall into such power lines or circuits. When installing an outside
antenna system, extreme care should be taken to keep from touching or
approaching such power lines or circuits, as contact with them m i g h t be
fatal. Installing an outdoor antenna can be hazardous and should be left to a
professional antenna installer.
Cleaning- Unplug this video product from the wall outlet before cleaning.
Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
Objects that may touch dangerous voltage points or "short-out" parts could result
in a fire or electric shock. Never spill liquid of any kind on the video product.
Lightning-For added protection for this video product during a lightning storm, or
when it is left unattended and unused for long periods of time, unplug it from the
wall outlet and disconnect the antenna or cable system. This will prevent damage
to the video product due to lightning and power line surges.
Servicing-Do not attempt to service this video product yourself, as opening or
removing covers may expose you to dangerous voltage or other hazards. Refer all
servicing to qualified service personnel.
Conditions Requiring Service-Unplug this video product from the wall outlet and
refer servicing to qualified service personnel under the following conditions:
A. When the power-supply cord or plug is damaged.
B. If liquid has been spilled, or objects have fallen into the video product.
C. If the video product has been exposed to rain or water.
D. If the video does not operate normally by following the operating instructions.
Adjust only those controls that are covered by operating instructions.
Improper adjustment of other controls may result in damage and will often
require extensive work by a qualified technician to restore the video product
to its normal operation.
E. If the video product has been dropped or cabinet has been damaged.
F.
When the video product exhibits a distinct change in performance-this
indicates a need for service.
Replacement Parts-When replacement parts are required, have the service
technician verify that the replacements he uses have the same safety
characteristics as the original parts. Use of replacements specified by the video
product manufacturer can prevent fire, electric shock, or other hazards.
Safety Check-Upon completion of any service or repairs to this video product, ask
the service technician to perform safety checks recommended by the
manufacturer to determine that the video product is in safe operating condition.
Wall or Ceiling Mounting- The product should be mounted to a wall or ceiling only
as recommended by the manufacturer.
Heat-The product should be situated away from heat sources such as radiators,
heat registers, stoves, or other products (including amplifiers) that produce heat.
Use
Service
Note to CATV system installer
This reminder is provided to call the CATV system installer's attention to
Section 820-40 o f t h e N E C w h i c h p r o v i d e s g u i d e l i n e s f o r p r o p e r g r o u n d i n g
and, in particular, specifies that the cable ground shall be connected to the
grounding system of the building, as close to the p o i n t of cable entry as
practical.
10.
11.
12..
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
CAUTION