Kawasaki Rotary Tool - Manual (Page 10)

T TY YP PE ES S O OF F A AC CC CE ES SS SO OR RIIE ES S
Y YO OU UR R R RO OT TA AR RY Y T TO OO OL L M MA AY Y B BE E U US SE ED D W WIIT TH H T TH HE E F FO OL LL LO OW WIIN NG G A AC CC CE ES SS SO OR RIIE ES S::
S Sa an nd diin ng g B Ba an nd dss:: These small drum sanders help
you shape and smooth surfaces in tight places.
Replace bands when they become worn. Bands
come in fine grades for finish and delicate work
and coarse grades for heavier work. Sanding bands
work best at lower speeds. Experiment with scrap
material before working on an actual project. To
use a sanding band, loosen the screw in the shank,
slip the band onto the shank, then tighten the
screw to secure the band.
B Brru ussh he ess:: Wire brushes are useful for cleaning
and polishing metal, while bristle brushes are
suitable for cleaning softer surfaces. As with all
rotary tool accessories, you should let the
speed do the work without applying excessive
force. Use the bristle tips only without mashing
the brush against the work piece as shown in
the top part of the illustration on the right.
N NE EV VE ER R R RU UN N B BR RU US SH HE ES S A AT T S SP PE EE ED DS S A AB BO OV VE E 1 15 5,,0 00 00 0 R RP PM M..
The brush could eject bristles at high speed which could become embedded in
your skin or which could cause other serious injury.
D Drriillll b biittss:: High-speed steel drill bits are suitable for
most drilling applications in wood, plastic, and thin
metal. For ceramics, drywall, or other specialized
applications, you will need to purchase an appropri-
ate drill bit.
C Cu uttttiin ng g w wh he ee ellss:: To prepare a cutting
wheel for use, remove the screw in the
center of the shank, mount the wheel,
and replace the screw.
18
A AS SS SE EM MB BL LE E R RO OT TA AR RY Y T TO OO OL L S ST TA AN ND D
F FO OR R M MO OD DE EL L 8 84 40 01 16 69 9::
The rotary tool stand is used to hold the rotary tool while using the flexible shaft.
1. Insert the bottom end of the tool holder into the matching slots in the base of
the stand.
Rotate the tool holder to position the tool clamp to the
right-hand side.
2. Rotate tool holder 90° clockwise to
lock it to the base.
3. Pull out on the tool holder clamp lever
to open the tool holder clamp.
4. Insert tool into the clamp from the top.
Make sure the tool is fully inserted to the ridge in the tool
body.
5. Push the tool holder clamp lever toward the tool until it snaps into the place
and firmly holds the tool in place.
For your convenience, accessories can be stored in the holes provided in the base
of the stand.
When the tool is left installed in the stand with the flexible shaft installed, hang the
collet end of the flexible shaft in the slotted holder at the rear of the stand.
17
15°
RIGHT
WRONG