Kenwood KNA-VC300 - Manual (Page 3)

The microphone should be mounted on the steering post or at some
other location where it may clearly pickup the driver’s voice.
• This microphone has directional characteristics: Please ensure that the
microphone surface is facing the driver.
• In order to ensure good voice recognition, please ensure that the holes
on the sides of the microphone are not covered in the installation
position.
• Please avoid installation of the microphone in the vicinity of air-
conditioner vents or in locations that are exposed to air blown in from the
windows.
• The microphone should be located between 20 and 40 cm (8 and 16 in.)
from the position of the driver’s mouth.
1 Remove the backing paper from the
double-sided sticking tape on the
microphone clip’s rear surface, and
then secure this clip on the steering
post or at some other location where
it will not hinder operation of the
vehicle.
2 Adjust the horizontal orientation of
the microphone in such a way that it
faces towards the driver.
3 Position the microphone cord.
Be sure to remove any grease or dirt
from the mounting surface before
positioning this component as failure to
do so will impair the tape’s ability to
stick securely.
Microphone Mounting
Microphone
clip
Direction
of the
driver
Microphone
surface
Microphone
cable
Backing
paper
KNA-VC300_6L r3 03.7.25 9:56 AM Page 5