Kunz MR44K User Manual
Page 10
The tongue is equipped with a screw pin shackle clevis to provide movement in all directions on
Figure 7: Rough Cut Tow Behind Towing Suggestions
B.
rough uneven ground. To prevent loss of the screw pin due to vibration or debris, place the screw
pin through the tow vehicle hitch and clevis and turn the screw pin until snug.
The tongue is designed to adjust from left to right within the hitch pivot. This allows the mowers
position to be varied behind the tow vehicle. This is accomplished by pulling the 5/16” wire lock
pins out and choosing two other hole locations on the tongue. See Figure 6.
Offset
Directly Behind
ADJUSTING CUTTING HEIGHT
WARNING: Shut off the engine and allow the mower blades to come to a complete stop
before adjusting the cutting height.
Lower Edge of
Deck
Mower
Blade
Adjustment Crank: Roughly 8
turns eq
Measure This Distance
Height
and Add 1-5/16” to get
Cutting
Cutting Height
1-5/16”
Smooth Surface
uals
1.0”
Figure 8: Adjusting Rough Cut Mower Cutting Height
9