Karcher K 5.20 M - Manual (Page 6)

6
English
Caution
„
Do not operate the appliance at temper-
atures below 0 °C.
„ Observe a distance of at least 30 cm
when using the jet to clean painted sur-
faces to avoid damaging paintwork.
„ Never leave the appliance unattended
when it is in operation.
„ Make sure that the power cable or ex-
tension cables are not damaged by run-
ning over, pinching, dragging or similar.
Protect the power cable from heat, oil,
and sharp edges.
„ All current-conducting parts in the work-
ing area must be protected against jet
water.
„ The appliance may only be connected
to an electrical supply which has been
installed in accordance with IEC 60364.
„ The appliance may only be connected
to alternating current. The voltage must
correspond with the type plate on the
appliance.
„ For safety reasons, we recommend that
you operate the appliance only via a
earth-leakage circuit breaker (max.
30 mA).
„ Cleaning operations which produce oily
waste water, e.g. engine washes, un-
derbody washes, may only be carried
out using washing stations equipped
with an oil separator.
„ This appliance was designed to be
used with detergents which are sup-
plied or recommended by the manufac-
turer. The use of other detergents or
chemicals may compromise the safety
of the appliance.
Illustrations on Page 3
Illustration
Î
Push the high pressure hose into the
trigger gun until it locks audibly.
Note: Make sure the connection nipple
is aligned correctly.
Î Check the secure connection by pulling
on the high-pressure hose.
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply
without a system separator. Use a
suitable system separator manufactured by
KÄRCHER; or, as an alternative, a system
separator as per EN 12729 Type BA. Water
flowing through a system separator is con-
sidered non-drinkable.
Note: Impurities in the water can damage
the high-pressure pump and accessories.
For protection, the use of the KÄRCHER
water filter (optional accessory, order no.
4.730-059) is recommended.
Observe regulations of water supplier.
For connection values, see type plate/tech-
nical data.
Î
Use a fibre-reinforced water hose (not
included) with a standard coupling.
(Minimum diameter 1/2 inch (13 mm),
minimum length 7.5 m).
Î Screw the water filter on the water con-
nection of the device.
Î Screw the delivered coupling part on
the water filter.
Î Push the water supply hose onto the
coupling unit, then connect it to the tap.
Operation
Before Startup
Water supply
Water supply from mains