Kustom HV 100TM - Manual (Page 9)

Mode l HV 100 Hybrid Tube Guitar Amplifier
Tube s Preamp 1-12AX7
Output Pow e r 100 W atts, RMS 4 Ohms @ 5% THD
Spe a ke rs 2 X 12 Inch Celestion Special design
Input Im pe da nce Single Input 100 K ohms
Hum & Noise -60 dBV Residual Noise, all level controls 0% (minimum)
Syste m Ga in 45 dBV Rhythm Channel Nominal gain, Volume @ 5
65 dBV Rhythm Channel Maximum gain, Volume @ 10
50 dBV Lead Channel Nominal gain, Volume @ 5
70 dBV Lead Channel Maximum gain, Volume @ 10
10 dBV Maximum gain of footswitchable Volume Boost
10 dBV Gain increase at 1 kHz when Gain Boost is pressed
6 dBV Gain increase at 1 kHz when Overdrive is pressed
27 ~ 37 dBV Power amp gain (Effects Return to Speaker, depending on Boost)
Nominal Signal to Noise 70 dBV Rhythm Channel, with Volume half and Master Maximum, Boost on 10
0.33 VRMS (-10 dBV) Levels w/Boost on 10 to reach full power output
1 VRMS (0 dBV) Levels w/Boost on 0 to reach full power output
Footswitchable Boost Master Volume Boost Adjustable from 0 to +10dB boost AFTER the Effects Loop
XLR Direct Output After power amp with speaker emulation
Digital Effects
USA/Canada 120VAC/60Hz, 180W nominal
Europe 230VAC/50Hz, 180W nominal
UK 230VAC/50Hz, 180W nominal
Australia 240VAC/50Hz, 180W nominal
Japan 100VAC/50-60Hz, 180W nominal
mm/kg 500 (Height) x 665 (W idth) x 300 (Depth), 23kg
Inches/Pounds 19 5/8 (Height) x 26 1/4 (W idth) x 11 3/4 (Depth), 51 lbs
Uses a standard stereo shielded cable, but can use mono cable for emergency limited functions.
Dimensions
Power Requirements
Footswitch
All measurements taken with
1 KHz input signal, Tone
controls flat, Boost volume
control at 0 unless stated
otherwise, Effects turned off.
Measured at speaker jack
with 4 ohm load.
Effects Loop
Use KACFS101M (sold separately) or standard momentary Footswitch with mono cable for Tap.
Use KACFS301 (sold separately) to Select Rhythm/Lead, Boost, Effects On/Off
24 bit DSP module, 16 effects w/programmable tap-toggle switch.
9
HV™ 100
Specifications