Konica Minolta KD-30M User Manual

Page 8

mm+

122mm+-2

Icon Index Table

Working Mode

Focus Range

Flash Modes

Digital Zoom

Thumbnails

Self-timer

Movie Clip

Memory Card Inside

Battery Status

Image Size (Resolution)

Image Quality

White Balance

Exposure

Protected Image

Print (DPOF)

Voice Memo

Darkness Warning

AUTO

Overall Introduction

Switch On or Off the Camera

Loading the Batteries

Getting Ready

Slide the "POWER" switch sideways and
hold it awhile to switch on the camera.
Repeat the action above to switch off the
camera.

1. Check if the camera is switched off.
2. Slide the Battery / Memory Card Cover out to open it.
3. Load 2 x AA batteries into the battery chamber, following the
polarity indications.
4. Close the Battery / Memory Card Cover.

Note
The symbols below are used to indicate the battery status on the TFT LCD
monitor.
( ):Battery power is full.
( ):Battery power is half drained. Have new batteries ready.
( ):Battery power is drained. Replace the batteries you are using now.

Note
The battery type shown below is recommended to ensure the normal operation
of the camera.

Brand Type

Duracell(Ultra) Alkaline