Kambrook EASY STEP KES110 - Manual (Page 7)

7
Operating Instructions
Before Using Your Easy Step
Cappuccino Maker
Wash the filter holder, stainless filters
and frothing jug in mild detergent and
water. Rinse and dry thoroughly.
It is recommended to carry out a
complete brewing operation with
cold water but without any coffee
before making your first espresso or
cappuccino (see Brewing Coffee). By
doing so, any residual dust left inside
the Easy Step Cappuccino Maker will
be removed.
Pre-warming Cups
For optimal coffee temperature, use
the cup warming plate on top of the
appliance to pre-warm the cups. The
cup-warming plate will be heating
whenever the appliance is switched
on at the power outlet.
How to Make an Espresso
Filling the water tank
• Switch the power off at the power
outlet and remove the plug.
• Ensure the Brew/Steam selector
control is in the ‘STANDBY’ position.
• The ‘STANDBY’ position is located
on the centre of sector control.
• Ensure the Pressure Indicator
Button on the Water Tank Cap has
dropped down and is flush with
the top of the cap.
Fig. 1
• Unscrew the water tank cap and
pour cold water into the tank. Fill
to 5mm below the visible water
pipes (Fig 1). Do not fill to the top
of the tank or there will not be
enough area to generate steam.
• Screw the water tank cap back
on top of the water tank, making
sure it is secured firmly before
operating the appliance.
NOTE: Do not use warm or hot
water to fill the water tank.
WARNING: Do not pour
water into the water
tank while the selector
control is in the brew or
steam position.
KES110_IB_FA.indd 7 2/12/09 8:37 AM