beautypg.com

Specifications – Kustom WAV 212 User Manual

Page 13

background image

Model

wAv 212

Stereo guitar amp with digital effects and selectable preamps

Input Impedance

Output Power

60W per channel

8 Ohms @ 5% THD

Hum & Noise

-50dB

Residual Noise, all level controls 0% (minimum)

30 dB

Lead Channel, Clean Preamp output

40dB

Lead Channel, Classic Preamp output

60dB

Lead Channel, Crunch Preamp output

60dB

Lead Channel, Wave Preamp output

6dB

Lead Channel added gain for all settings with Boost on

35dB

Rhythm Channel, Shift Out

40dB

Rhythm Channel, Shift In

35dB

Power amp gain

USA/Canada

120VAC/60Hz, 200W nominal

Europe

230VAC/50Hz, 200W nominal

UK

230VAC/50Hz, 200W nominal

Australia

240VAC/50Hz, 200W nominal

Japan

100VAC/50-60Hz, 300W nominal

mm/kg

540 (Height) x 700 (Width) x 280 (Depth), 25.4kg

Inches/Pounds

21.25 (Height) x 27.5 (Width) x 11 (Depth), 56 lbs

Dimensions

Power Requirements

Digital Effects

Footswitch

System Gain

All measurements taken with 1 KHz
input signal, Tone controls flat, Gain
and Volume Maximum Boost off
unless noted. Measured at preamp
output jacks on rear unless noted.

There are 45 selectable effects separated into 3 groups of 15. One effect from each group
active at the same time. Up to 3 groups active at the same time.
There are 12 user presets. Each preset stores all setting for the 3 groups. There are 4
Favorites banks. Each favorites bank contains 3 user presets. Presets in the banks are
selected by tracking the channel select and Lead Boost button status.

Total Harmonic Distortion

Frequency Response

20HZ-20kHz

Actual response is tailored to speakers for accurate acoustical
response using a guitar as input.

Less than 0.4%

Because of the intentional distortion created by using some of the
preamps and effects, this Distortion is measured from the power
amp input signal to the output to speakers.

200K Ohm

18 Bit 44.1Khz sampling rate Stereo Processor with onboard firmware flash memory

64K User Memory

Use any standard CAT 5 cable wired to the 568A or 568B standard

Use only with Model: KAC-FSWAV (supplied with amplifier)

13

Specifications