Kambrook KSK65 - Manual (Page 5)

5
and steam will scald. Do not pour
the water too quickly.
• To protect against electric shock,
do not immerse the kettle base,
power base, power cord or power
plug in water or allow moisture to
come in contact with these parts.
• Do not remove the kettle from the
power base during operation.
Ensure the kettle has switched
off after the water has boiled or
reached the selected temperature,
before removing the kettle from
the power base. If the kettle is
removed from the power base
during the boiling cycle the kettle
will automatically switch off.
• Do not move the kettle while it is
switched on.
• Do not open the lid during
operation.
• Keep the kettle clean. Follow the
cleaning instructions provided in
this book on (page 9).
Important Safeguards For All Electrical
Appliances
• Fully unwind the power cord before
use.
• Do not let the power cord hand
over the edge of a bench or table,
touch hot surfaces or become
knotted.
• To protect against electric shock
do not immerse the power cord,
power plug or appliance in water
or any other liquid.
• The appliance is not intended for
use by persons (including children)
with reduced physical, sensory
or mental capabilities, or lack of
experience and knowledge, unless
they have been given supervision
or instruction concerning use of the
appliance by a person responsible
for their safety.
• Children should be supervised to
ensure that they do not play with
the appliance.
• It is recommended to regularly
inspect the appliance. To
avoid a hazard do not use the
appliance if power cord, power
plug or appliance becomes
damaged in any way. Return the
entire appliance to the nearest
authorised Kambrook Service
Centre for examination and/or
repair.
• Any maintenance other than
cleaning should be performed at
an authorised Kambrook Service
Centre.
• This appliance is for household use
only. Do not use this appliance for
anything other than its intended
use. Do not use in moving vehicles
or boats. Do not use outdoors.
Misuse may cause injury.
• The installation of a residual
current device (safety switch)
is recommended to provide
additional safety protection when
using electrical appliances. It is
advisable that a safety switch with
a rated residual operating current
not exceeding 30mA be installed in
the electrical circuit supplying the
appliance. See your electrician for
professional advice.
KSK65_IB_FA.indd 5 18/11/09 9:35 AM