Presetting disc names, Disc name preset play (dnpp), Md/external disc control features – Kenwood MD-RECEIVER KMD-870R User Manual

Page 22

If you have preset the name of a disc that you want to listen to
in the disc changer, you can look for it by name and start
playing it.

Disc Name Preset Play (DNPP)

Function of remote control with DNPP button

The operation and characters that can be entered may change
as listed below, depending on the unit that is connected.
A press of the

38 button exits the disc name preset mode.

Operations can be followed again from Step 2 at a time such
as this, and the characters to be input are selected using the
procedure described below.
Press the DISC

or DISC

–

button to display the desired

character. Besides the alphabet (capital letters only) and
numbers, you can choose the following characters: /,

–

, *,

=, <, >, [ and ].

Continue steps 3 and 4 until all the characters are chosen for
the name.

Press either the NAME.S button on the main unit or the OK
button on the remote control.
The disc name is stored and the disc name preset mode is
cancelled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.

• The number of characters and discs whose names can be

stored will differ depending on the disc changer that is
connected. Please see your disc changer manual for details.

• Discs are identified by their total length and number of tracks. If

another disc happens to have the same specifications as one
that you have already stored a name for, the name will be
displayed for it, too.

• If you want to change the name of a disc, repeat steps 1 and 2

to display the name, and then repeat steps 3 and 4 to input the
changes.

• Pressing the reset button does not erase the disc names stored

in a disc changer.

NOTE

Store the names of discs to be displayed when played.

Play the disc whose name you want to preset.

• This function is not available for disc changers that do not

feature the Disc Name Preset function.

• This procedure is not to be used to store the disc and track titles

for MDs that you record.

Hold down the NAME.S button for two seconds or more.
"NAME SET" is displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.

Press either the

4 or ¢ button to move the cursor to the

desired position.
The

4 button moves the cursor to the left, and the ¢

button to the right.
You can also move the cursor left or right by pressing the
TRACK

or TRACK

–

buttons, respectively, on the remote

control.

Each time the

38 button is pressed, the characters to be

entered change as listed below.
Press the DISC

or DISC

–

button to display the desired

character.
Characters that can be displayed are as follows.

Alphabet (upper case): A ~ Z

Alphabet (lower case): a ~ z

Numerals and symbols: 1~9 0 @ ” ‘ ` % &

∗

+ - = , . / \ < > [ ]

Special characters: б а й и н м у т ъ щ С З ® Я ‹ fl в д к

NOTE

Presetting Disc Names

(

Function of disc changers)

MD/External disc control features

— 22 —

English