Kenwood DPX-MP2090U - Manual (Page 11)

English | 11
System Q
Selecting the best sound setting preset for
different types of music.
1 Select the source to set
Press the [SRC] button.
2 Select the Sound type
Press the [Q] button.
When you press the button once, the current
sound setting is displayed.
Each time you press the button, the sound
setting alternates.
Sound setting Display
User memory "USER"
Rock "ROCK"
Pops "POPS"
Easy "EASY"
Top 40 "TOP 40"
Jazz "JAZZ"
Natural "NATURAL"
• User memory: The values set on the
(page 11).
• Change each setting value with the
Setting> (page 13).
First, select the speaker type with the Speaker setting.
Audio Control
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Control mode
Press the [VOL] knob.
3 Select the Basic Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4 Adjust the Basic Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Rear Volume * 1 "R-VOL" 0 — 35
Subwoofer level* 2,3 "SW L" –15 — +15
Bass level* 4 "BAS L" –8 — +8
Middle level* 4 "MID L" –8 — +8
Treble level* 4 "TRE L" –8 — +8
Balance "BAL" Left 15 — Right 15
Fader* 3 "FAD" Rear 15 — Front 15
Exit Audio Control mode (Volume control mode)
• * 1 You can control this item when "2ZON" of
Setup> (page 12) is set to "ON".
• * 2 You can control this item when
(page 27) is set to "SWPRE SW".
• * 2 You can control this item when
Output> (page 13) is set to "SW ON".
• * 3 You can control this item when "2ZON" of
Setup> (page 12) is set to "OFF".
• * 4 You can adjust these items in detail. Refer to
(Page12).
• * 4 Source tone memory: Puts the set up value in the
memory per source. (Detail Audio item is included)
5 Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob and
[ATT] button.