beautypg.com

Complete installation – Kenmore ELITE HE5 110.8708 User Manual

Page 18

background image

18

4. Move hinge to the other side and reattach with the 4 screws

removed in Step 3. Make sure locator pins line up in holes
and drive the top 2 screws in place first to help drive locator
pins into proper location.

5. Set the inner door assembly aside.

Reverse the door handle

1. Place the outer door assembly face down on work space.

2. Remove the 6 screws that hold the intermediate door to the

outer door assembly. Remove the intermediate door, and set
hinge shield aside. Remove the hinge hole cover.

3. Rotate the window assembly 180º and reattach the

intermediate door, hinge shield and hinge hole cover with the
6 screws removed in Step 2.

Reinstalling the door

1. Place the inner door assembly into the outer door assembly.

To fit correctly, the inside door assembly edge is completely
inside the outside door assembly edge.

2. Reassemble the inner and outer door assemblies with the

5 screws.

3. Remove existing label from the opposite side of the door and

discard. Find label provided with the Use and Care Guide and
apply over original hinge holes.

4. Align the door by placing the locating tabs on the hinge with

the locating holes on the dryer front panel. Insert and tighten
the center hinge screw. The door will hang in place while you
insert and tighten the remaining 4 screws.

NOTE: Two or more people may be needed to reattach the
dryer door.

5. Close the door and check that it latches securely.

6. Check for fingerprints on the glass. Clean the glass if

necessary.

Complete Installation

1. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.

3. Dispose of/recycle all packaging materials.

4. Check the dryer’s final location. Be sure the vent is not

crushed or kinked.

5. Check that the dryer is level. See “Level Dryer.”

6. For power supply cord installation, plug into an outlet. For

direct wire installation, reconnect power.

7. Remove the blue protective film on the console and any tape

remaining on the dryer.

8. Read “Dryer Use.”

9. Wipe the dryer drum interior thoroughly with a damp cloth to

remove any dust.

10. Select a Timed Dry heated cycle, and start the dryer. Do not

select the Air Only Temperature setting.

If the dryer will not start, check the following:

Controls are set in a running or “On” position.

Start button has been pushed firmly.

Dryer is plugged into an outlet and/or electrical supply
is connected.

Household fuse is intact and tight, or circuit breaker has
not tripped.

Dryer door is closed.

11. When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and
close the door.

If you do not feel heat, turn off the dryer and check the
following:

There may be 2 household fuses or circuit breakers for
the dryer. Check that both fuses are intact and tight, or
that both circuit breakers have not tripped. If there is still
no heat, contact a qualified technician.

NOTE: You may notice a burning odor when the dryer is first
heated. This odor is common when the heating element is first
used. The odor will go away.

A. Intermediate door
B. Hinge shield

C. Hinge hole cover

B

A

C

A. Dryer door
B. Dryer front panel

C. Insert this hinge screw first.

B

C

A

This manual is related to the following products: