Karcher K 460 M - Manual (Page 4)

You will need a standard screw driver OR a Torx T-25 screw driver
Step 4
Slide the spray wand
extension into the gun. Turn the wand
collar onto the gun threads until tight.
3
ASSEMBLY INSTRUCTIONS
Step 3
Slide the hose caddy into the handle
slots and snap into place.
Step 1
Attach the mobile adapter brackets to
the pressure washer. Align holes on the bottom
of the pressure washer as shown and tighten the
4 screws.
Step 2
Spread handle sides
apart and align with slotted areas of
mobile adapter brackets and snap into
position. Tighten the 4 screws.
Water Supply
(Cold Water Only)
• Water hose must be at least 3/4 inch in
diameter.
• Flow rate of water supply must not fall
below 2.5 GPM (gallons per minute).
• Flow rate can be determined by running
the water for one minute into an empty
5-gallon container.
IMPORTANT PRECAUTIONS – continued
• The water supply temperature must not
exceed 104°F/40°C.
• Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
• Always prevent debris from being drawn
into the unit by using a clean water source.