How to install the wall mount bracket – SRS Labs Plasma Display Panel Television User Manual
Page 34
![background image](/manuals/155921/34/background.png)
English - 34
Instructions on Securing the SET to the Wall Mount Bracket
➢
The exterior of the SET may be different than the picture. (Assembly and installation of the plastic hanger is
the same.)
1
Remove the screws from the back of the PDP.
2
Use the screw and assemble the plastic hanger.
(Please refer to the following picture.)
☛
1 Please ask the installers to install the wall
mount bracket.
2 Please be sure to check if the plastic hanger is
completely secured on both the left and right
side after hanging the SET on the wall mount
bracket.
3 Please avoid catching your fingers while
installing and adjusting the angle.
4 Please tightly secure the wall mount bracket to
the wall to avoid injury from a falling SET.
How to Install the Wall Mount Bracket
3
Tighten the screws of the plastic hanger (shown
in picture 2) to the back side of the PDP.
4
Remove the Safety Pins. Fasten the 4 plastic
latches assembled at step (#) on the back side of
the PDP using the guide holes of the wall mount,
push (!) and hook (@) down to secure the PDP on
the wall mount as illustrated. Secure the PDP by
inserting the Safety Pins.
continued...
PDP panel
Wall attachment
panel bracket
Wall
BN68-00889W-01Eng(Spa) 9/20/06 3:15 PM Page 34