beautypg.com

Before starting the engine, Add engine oil, Add fuel – Snapper 030215-1 User Manual

Page 7: Caution, Warning

background image

7

Snapper 5600W Portable Generator

6.

Repeat step 3 through 5 to secure second wheel.

7.

Attach vibration mounts to support leg with 1/4-20 x 1”
capscrews and 1/4-20 lock nuts.

8.

Tip generator so that engine side is down.

9.

Remove existing hardware from left unit vibration
mount with 13mm wrench. Use same hardware to
attach support leg.

10. Attach other side of support leg with a M8 x 20 mm

capscrew and M8 lock nut.

11. On support leg end of generator, slide handle onto

center of top of frame.

12. Attach handle using two long (M8 x 45mm) cap screws

and two locking hex nuts.Tighten with a 1/2” or 13mm
socket and wrench.

13. Return generator to normal operating position (resting

on wheels and support leg).

14. Check that tires are inflated to value marked on tire

or within 15 and 40 psi.

BEFORE STARTING THE

ENGINE

Add Engine Oil

• Place generator on a level surface.

• Refer to engine operator’s manual and follow oil

recommendations and instructions.

NOTE: Check oil often during engine break–in. Refer to
engine operator’s manual for recommendations.

NOTE: The generator assembly rotates on a prelubricated
and sealed ball bearing that requires no additional
lubrication for the life of the bearing.

Add Fuel

NOTE: This gasoline engine is certified to operate on
gasoline. Exhaust Emission Control System: EM (Engine
Modifications).

1.

Use clean, fresh, regular UNLEADED fuel with a
minimum of 85 octane. DO NOT use fuel which
contains Methanol. DO NOT mix oil with fuel.

2.

Clean area around fuel fill cap, remove cap.

3.

Slowly add regular unleaded fuel to fuel tank. Be careful
not to overfill. Allow about 1.5" of tank space for fuel
expansion (Figure 2).

4.

Install fuel cap and wipe up any spilled fuel.

CAUTION

• Refer to engine operator’s manual for oil fill information.

• Damage to equipment resulting from failure to follow this

instruction will void warranty.

Any attempt to crank or start the engine before it has
been properly filled with the recommended oil will result
in equipment failure.

WHEN ADDING FUEL
• Turn generator OFF and let it cool at least 2 minutes before

removing fuel cap. Loosen cap slowly to relieve pressure in
tank.

• Fill fuel tank outdoors.

• DO NOT overfill tank. Allow space for fuel expansion.

• Keep fuel away from sparks, open flames, pilot lights, heat, and

other ignition sources.

• DO NOT light a cigarette or smoke.

Fuel and its vapors are extremely flammable and
explosive.
Fire or explosion can cause severe burns or
death.

WARNING

Fuel

Tank

1.5” Air

Space

Figure 2 - Fuel Expansion

• Always wear eye protection when installing/removing e-rings.

E-rings can cause eye injury.
E-rings can spring back and become airborne
when installing or removing.

CAUTION