Assembly, Unpacking the generator, Carton contents – Snapper 030215-1 User Manual
Page 6: Install wheel kit
Snapper 5600W Portable Generator
6
ASSEMBLY
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-317-7833. If calling for assistance, please have the
model, revision, and serial number from the data tag available.
Unpacking the Generator
1.
Set the carton on a rigid flat surface.
2.
Remove everything from carton except generator.
3.
Open carton completely by cutting each corner from
top to bottom.
4.
Leave generator on carton to install wheel kit.
Carton Contents
Check all contents against those listed below:
• Main unit
• Engine oil
• Operator’s manual
• Engine operator’s manual
• Wheel kit
If any parts are missing or damaged, call the generator
helpline at 1-800-317-7833.
Install Wheel Kit
NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 1/2" or 13mm wrench
• Socket wrench with a 1/2" or 13mm socket
• Pliers
• Safety goggles
Refer to Figure 1 and install the wheel kit as follows:
1.
Tip generator so that engine end is up.
2.
Slide axle through both mounting brackets.
3.
Place a wheel on each side with air valve facing out.
4.
Place a washer on axle and then place an e-ring in axle
groove.
5.
Install e-ring with pliers, squeezing from top of e-ring
to bottom of axle.
Support Leg
Hex Nut
Axle
Flat Washer
Cap Screw
Handle Assembly
Hex Nut
Wheel
E-Ring
Figure 1 — Install Wheel Kit
Cap Screw
Hex Nut
Cap Screw
Vibration Mount
Use existing hardware
to attach left side of
support leg to unit
Typical Generator Shown