Staber Industries HXD2304E - Manual (Page 5)

TO RESTART YOUR DRYER
1 Close the door.
2 Select a new cycle and temperature (if desired).
3 Press the START button.
LOADING
• Place only one wash load in the dryer at a time.
• Load clothes loosely into the dryer which allows space for clothes to tumble freely.
• Mixed loads of heavy and lightweight clothes will dry differently. Lightweight clothes will dry,
while heavy clothes may be damp.
• Add one or more similar items to the dryer when only one or two articles need drying. This
improves the tumbling action and drying efficiency.
• Overloading restricts tumbling action, resulting in uneven drying as well as excessive wrinkling
of some fabrics.
• When drying large, bulky items such as a blanket or comforter, it may be necessary to
reposition the load during the cycle to ensure even drying.
• Do not pack the dryer.
PLEASE REFER TO PAGE 7 OF THE WHIRLPOOL USE & CARE GUIDE FOR ADDITIONAL
INFORMATION ON LOADING.
DRYING, CYCLE AND TEMPERATURE TIPS
PLEASE REFER TO PAGE 8 OF THE WHIRLPOOL USE & CARE GUIDE.
CYCLES
PLEASE REFER TO PAGE 8 OF THE WHIRLPOOL USE & CARE GUIDE.
CARE & CLEANING
CLEANING THE LINT FILTER
Clean the Lint Filter:
• After each load.
• To shorten drying time.
• To operate more energy efficiently.
The lint filter can be found on the top of the dryer. Drying time can be increased if your filter is
clogged by lint.
To clean
1 Pull the lint filter towards you. Roll lint off the filter with your fingers. Do not rinse or wash filter
to remove lint. Wet lint is hard to remove.
2 Push the lint screen firmly back into place.
IMPORTANT:
• Do not run the dryer with the lint filter loose, damaged, blocked, or missing. Doing so can
cause overheating and damage to both the dryer and fabrics.
• Some towels made of synthetic fibers and natural fibers (polyester and cotton blends) may
shed more lint than other towels, causing your dryer’s lint filter to fill up faster. Before and after
drying new towels be sure to remove lint from the lint filter.
• Check the exhaust hood and remove the lint if lint falls off the filter into the dryer during
removal. See “Checking Your Vent.”
5