Sony KDL-40S20L1 - Manual (Page 12)

Getting Started
12
Cable Box/Digital
Cable Box Use this hookup if
s
You subscribe to a cable TV system that uses scrambled or encoded
signals requiring a cable box to view all channels, and
s You do not intend to hook up any other audio or video equipment to
your TV.
Also, set Cable to On in the Cable settings in Setup settings (see page
34).
Cable System and
VHF/UHF Antenna
System If you want to watch both antenna (over-the-air) and cable broadcast signals,
you’ll need to use an optional A-B RF switch (not supplied), as shown
below.
Use the A-B selector to switch between the
over-the-air signals and the cable signals. Then
set the
Cable setting in the Setup settings to On
or Off , as described on page 34.
z To change channels using
the cable box, set your TV
to channel 3 or 4
depending on the cable
box channel output.
Auto Scan will fix the
channel automatically.
75-ohm coaxial
cable (supplied)
Cable
IN
jack
OUT
jack
Rear of TV
VHF/UHF input
A
B
A
Cable
Antenna
A/B
RF Switch
Rear of TV
VHF/UHF input