Sundance Spas 7'7-inch x 7'7-inch and Smaller - Manual (Page 5)

4
Top edges flush
Step 2
Assemble the Wall Sections
You will need a 10' x 10' clear, level
assembly area.
Lay out the pieces of a single wall section
as shown in Diagram 2.
A single wall section consists of:
one 2"x4"x77-1/2" Header [4],
two Lattice Panels [1],
and two 2"x3" Uprights [3].
Step 3
Position the 2" x 3" uprights on the
inside edge of each lattice panel as
shown in Diagram 3. The notches in the
uprights should be face up.
Make sure that the top of the uprights
are flush with the top of the lattice
zpanels.
Attach the uprights to the panels with
four 2-1/2" screws each as shown.
Step 4
Choose four lattice panels with
attached 2”x 3” uprights. Attach a 2"x2"
Corner Upright [2] to the outside edge
of each lattice panel with four 2-1/2"
screws as shown in Diagram 4.
Sundance Spas Gazebos Installation Instructions WillowWood
Diagram 2
Diagram 3
Diagram 4