Sanyo CLT-J30 - Manual (Page 28)

28
Dial tone is OK, but cannot dial out
•
Make sure the TONE/PULSE dialing mode is set to TONE or PULSE
according to your phone service.
Handset does not ring
•
Make sure the RINGER switch on the handset is turned to ON.
•
You may have too many extension phones on your line. Try
unplugging some phones.
•
See solutions for No dial tone.
You experience static, noise, or fading in and out
•
Change channels.
•
Is handset out of range? Move closer to the base.
If you hear 3 short beeps when you press TALK/CALL BACK, you
are out of range.
•
Does the base need to be relocated?
•
Charge battery.
•
Make sure base is not plugged into an outlet with another house-
hold appliance.
Phone beeps
•
Place handset in base for a minimum of 20 seconds to reset the
security code. If that does not work, charge battery for 12
continuous hours.
•
Clean charging contacts on handset and base with a soft cloth or
an eraser.
•
See solutions for No dial tone.
•
Replace battery.
Dialing from Memory
•
Did you program the directory keys correctly?
•
Did you follow proper dialing sequence?
•
Make sure the TONE/PULSE dialing mode is set to TONE or PULSE
according to your phone service.
•
Did you reprogram directory after a power outage or battery
replacement?
TROUBLESHOOTING