Scag Power Equipment FREEDOM Z SFZ48-26BS - Manual (Page 25)

21
R
Section 6
PARKING BRAKE ADJUSTMENT 6.1
WARNING
Do not operate the mower if the parking brake
is not operable. Possible severe injury could
result.
The parking brake linkage should be adjusted whenever the
parking brake lever is placed in the “ENGAGE” position and
the parking brake will not prevent the mower from moving.
If the following procedures do not allow you to engage the
parking brake properly, contact your Scag dealer for further
brake adjustments.
Park the machine on a flat surface and block the 1.
caster wheels to prevent the machine from moving.
Remove the ignition key.
Disengage the parking brake. See Figure 6-1. 2.
Release the seat hold down latch and tilt the seat 3.
forward to gain access to the brake control linkage.
Remove the cotter pin securing the pivot to the brake 4.
control linkage. See Figure 6-2.
Push down on the brake control rod to disengage the 5.
parking brake and adjust the pivot until it meets the
mounting hole. Insert the pivot into the brake control
linkage and secure with the cotter pin.
Repeat steps 4 and 5 on the other side of the 6.
machine.
Test the parking brake. 7.
- Note -
If this procedure does not achieve proper brake
adjustment, please contact your authorized Scag
dealer.
ADJUSTMENTS
RELEASE BRAKE
HANDLE
Brake Adjustment Figure 6-1.
ADJUST HERE
Brake Rod Adjustment Figure 6-2.