Schumacher INSTANT POWER Jump Starter and DC Power Source IP-125 - Manual (Page 9)

• 5 •
FEATURES 6.
Charged/Charging LEds 1.
Battery Status LEds 2.
Battery Status Button 3.
12v dC Power Outlet 4.
1 2
3
4
CHARGING THE INTERNAL BATTERY OF THE INSTANT POWER™ 7.
IMPORTANT: CHARGE IMMEDIATELY AFTER PURCHASE, AFTER EACH
USE AND EVERY 30 DAYS TO KEEP THE INSTANT POWER™ INTERNAL
BATTERY FULLY CHARGED.
LED Indicators:
7.1
TO CHECK THE INTERNAL BATTERY’S CHARGE STATUS, PRESS THE
BATTERY STATUS BUTTON ON THE FRONT OF THE INSTANT POWER™.
The LEd lights will indicate the charge level as follows:
A red LEd • indicates a 50% or less charge and you should immediately
recharge the Instant Power™.
A yellow LEd
• indicates a 50 to 75% charge. The Instant Power™ may
be used but should be recharged as soon as possible.
A green LEd
• indicates the internal battery is fully charged.
The CHARgINg • (red) LEd indicates the Instant Power™ is charging
(connected to an AC power source.) At full charge, the CHARgEd
(green) LEd will light.
Charging the Internal Battery using the Built-In Charger: 7.2
To charge, plug an 18 gauge (AWg) or larger extension cord into the 1.
charger plug on the right side of the Instant Power™. (Extension cord not
included; must be purchased separately.)
Plug the extension cord into a 120v AC electrical wall outlet.
2.
The CHARgINg 3. (red) LEd will glow indicating charging.
The CHARgEd 4. (green) LEd will light when the battery has reached
full charge. This could take up to 72 hours due to the age and condition
of the battery. The charger will automatically go into maintain mode and
maintain the battery at full charge without damaging it.