StarTech.com ST100S - Manual (Page 4)

Instruction Manual
1
Thank you for purchasing a StarTech.com 10/100 Mbits/sec PCI Ethernet card. Featuring
Auto-Negotiation capability and support for data transmission bandwidth from 10Mbps to
100Mbps, the card is easy to install and set up, and is fully Plug and Play compatible in a
wide range of operating environments.
Introduction
• Support for IEEE802.3x Full-Duplex flow control
Features
System requirements:
• An IBM-compatible computer with a Pentium-based processor
Package contents:
• 1 x PCI Ethernet Adapter card
This package should contain:
• Capable of full and half-duplex communications
• Complies with industry standards: IEEE 802.3, 100BaseTX and 10BaseT standard
• Supports 32-bit PCI Bus Master for high performance and low processor utilization
•
One of the following operating environments: Windows Vista/XP/ME/2000/98/95,
Windows NT, Linux, NetWare 3.x/4.x, Lan Manager, TCP/IP software
• An available PCI slot
• 1 x Driver disk
• 1 x Installation Guide
• 1 x Full-size Bracket (ST100SLP only)