Schumacher XP2260 - Manual (Page 10)

• 7 •
Appliance Type Estimated Wattage Estimated Usage Time
Cell Phone 4 watts 66 hours
Fluorescent Light 4 watts 66 hours
Radio, Fan 9 watts 29.3 hours
Depth Finder 9 watts 29.3 hours
Camcorder, VCR 15 watts 17.6 hours
Electrical Tool 24 watts 11 hours
Electrical Cooler 48 watts 5.5 hours
Car Vacuum, Air Compressor 80 watts 3.3 hours
NOTE: Estimated run-times. Actual time may vary. Times are based on the
internal battery being fully charged and in good condition.
Using the USB Port
5.4
The USb port provides up to 500mA at 5V DC.
Ensure the battery clips are securely clipped on the storage holders. 1.
Turn the Instant Power™ On/Off switch to the ON position. 2.
Turn the USb device on. 3.
Reverse these steps when finished using the USB port. 4.
Charge the Instant Power™ as soon as possible after using the USb port. 5.
Using the Built-In Light 5.5
Position the Instant Power™ on a flat, stable surface near the intended 1.
work area.
Ensure the battery clips are securely clipped on the storage holders.
2.
Press the Light Switch to the ON position. 3.
The Instant Power™ light will turn on and illuminate your work area. 4.
Press the Light Switch to the OFF position. 5.
Charge the Instant Power™ as soon as possible after using the built-in 6.
light.
Using the Air Compressor 5.6
Risk of explosion.
Read the instructions of the product being inflated before using the
compressor. Avoid over inflation, do not exceed the manufacturer’s
recommended pressures. Do not leave the air compressor
unattended during use.
Ensure the battery clips are securely on the storage holders. 1.
Remove the air compressor hose from the storage compartment in the 2.
back of the Instant Power™. Install adapters as necessary.
Attach the air compressor hose to the product or accessory to be inflated
3.
by flipping down the lever.
Place the Compressor/Inflator Switch in the COMPRESSOR position and
4.
inflate the product.
When the product is inflated to the proper air pressure (using the air
5.
compressor gauge) place the Compressor/Inflator Switch in the OFF
position and remove the hose.
Do not run for more than 10 minutes maximum at a time. Allow the Instant
6.
Power™ to cool down for 10 minutes before using again.