Standard Horizon QUANTUM GX2360S - Manual (Page 45)

Page 45 GX2360S
reference in the directory.
7. Press the [CALL/SET(MENU)] key to store the first
letter in the name.
8. Repeat step 6 and 7 until the name is complete.
The name can consist of up to eleven characters, if
you do not use all eleven characters press the
[CALL/SET(MENU)] key to move to the next space.
This method can also be used to enter a blank space
in the name. To clear the previous letter, press the [H/L(NAV)] key.
9. After the eleventh letter or space has been entered, press the
[CALL/SET(MENU)] key to advance to the GROUP MMSI (Maritime Mo-
bile Service Identity Number) number entry.
10. Turn the CHANNEL selector knob to scroll through
numbers, 0-9.
11. To enter the desired number and move one space
to the right press the [CALL/SET(MENU)] key. Re-
peat procedure until all nine spaces of MMSI num-
ber are entered.
12. If a mistake was made entering in the name or the
M M S I n u m b e r r e p e a t p r e s s i n g t h e
[CALL/SET(MENU)] key until the wrong character is selected, then move
the CHANNEL selector knob to correct the entry.
13. To store the data entered, press and hold the [CALL/SET(MENU)] key.
14. To enter another individual address, repeat steps 4 through 13.
15. To exit this menu and return to radio operation mode press the [16/9] key.
7.8.1.2 Transmitting a Group Call
1. Select the desired channel to use Group Call for
voice communications.
2. Press the [CALL/SET(MENU)] key. The “DSC OP-
ERATION” menu will appear.
3. Turn the CHANNEL selector knob to select
“GROUP.” (To cancel, select “EXIT” with the CHAN-
NEL selector knob or press [16/9] key.)
4. Press the [CALL/SET(MENU)] key. The transceiver
will beep, and the “Group directory” will appear.
5. Turn the CHANNEL selector knob to select the
“Group” you want to contact.
6. Press the [CALL/SET(MENU)] key to transmit the Group Call signal.
7. When the Group Call signal is sent, the dot-matrix area of the LCD will be
as shown in the illustration at the right.