Standard Horizon QUANTUM GX2360S - Manual (Page 33)

Page 33 GX2360S
6.22.1 Communication
1. Press and hold the [DW(IC)] key while in the “RA-
DIO” mode, the mode is changed to “INTERCOM”
mode.
2. If your QUANTUM is equipped two RAM+ Mic’s, se-
lect the companion you wish to communicate (RAM1,
RAM2, or ALL) with the CHANNEL selector knob,
then press the [CALL/SET(MENU)] key.
2. When the “INTERCOM” operation is
activated, “INTERCOM” is displayed
on the QUANTUM, and “IC” is dis-
played on the RAM+ Mic.
3. Press the PTT switch. “TALK” will be
shown on the display.
NOTE: A warning beep will be emit-
t e d w h e n t h e Q U A N T U M
microphone’s PTT switch is pressed
while the RAM+ Mic’s PTT switch is pressed.
4. Speak slowly and clearly into the microphone, hold the microphone about
1/2 inch away from your mouth.
5. When finished, release the PTT switch.
6. Press and hold the [DW(IC)] key again the mode will revert to “RADIO”
mode.
6.22.2 Calling
Hold down the [DW(IC)] key for 1 second or more, when the “INTERCOM”
operation is activated. A calling beep is emitted twice from the transceiver
speaker.
NOTE
When both RAM+ microphones are intercom
mode, the QUANTUM will be temporarily disabled
until the RAM+(s) exit the RAM+ to RAM+ inter-
com mode.
(RAM+ Mic’s PTT switch is pressed)
(QUANTUM’s PTT switch is pressed)