SPT WA-1310H - Manual (Page 5)

4
BEFORE USE
Important!
Transport the unit in an upright position only or leave in upright position
for at least 2 hours before use. Keep at least 20 inches away from the
wall. (Figure 1 & 4)
Always place the unit on an even surface.
Make sure the unit is connected to a correctly grounded power supply
(refer to the rating label located at the back of the unit).
An opening in a window or wall is required to accommodate the
exhaust hose (kit supplied) to expel the warm air.
Do not cover or obstruct the appliance inlet or outlet grilles (Figure2).
To avoid the risk of shock, the product should never be used in
bathrooms, shower rooms or in any other steamy/wet areas (Figure 3).
The unit will cool when the room temperature is between 64
°
F and
110
°
F depending on the thermostat setting.
Do not sit or place objects on the unit.
Do not touch the unit with wet/damp hands or when standing barefoot.
Avoid all contact with chemical based materials.
The filter must be used with the product at all times. When removing for
cleaning, always disconnect the power first.
Turn off the appliance when not in use.
For storage, drain all water and clean the unit / filters before storage.
Drainage of the water container is required before moving the unit or
putting it into storage.
If the electric socket is different from the plug provided, have a qualified
electrician replace the plug with a suitable one. Avoid the use of
adaptors, multiple sockets and/or extension cords; if their use is
necessary, ensure that they conform to the current safety regulations.
Do not pull the power cord or place it near a source of heat; always
unroll it completely to avoid the possibility of dangerous overheating.
If the power cord is damaged, it must be replaced by a service agent or
a similarly qualified person.
THE MANUFACTURER DISCLAIMS ANY RESPONSIBILITY IF THE
ABOVE INSTRUCTIONS ARE NOT FOLLOWED.
FIG. 1
FIG. 2
FIG. 3
FIG. 4
05-03-457 A029-OK.PDF
20"
20"