SPT WA-1310H - Manual (Page 13)

Regulating air flow direction
FIG. 19
Adjust louver on the air vent horizontally to
control air flow direction.
NOTICE !
The compressor will start approximately 3 minutes after the compressor is turned off (this
will help prolong the life of the compressor). After switching the unit off, please wait at
least 3 minutes before turning the unit back on.
The cooling system will switch off if the room temperature is 1ºF lower than set. The fan,
however, keeps working at the set level. If the ambient temperature rises above the chosen
level +2ºF, cooling will resume.
In heating mode, the compressor will switch off if the room temperature is 1ºF HIGHER than
the one set. As the room temperature drops below the chosen temperature –2ºF, heating will
resume.
This machine is equipped with an ANTI-FROST function. While using the heating function during
low temperatures, sometimes the heating will stop for a while to melt the internal frost. When this
occurs, just wait for heating to resume.
12
05-03-457 A029-OK.PDF