Smeg DWD63BLE - Manual (Page 8)

ON/START
Switch on the dishwasher by pressing the ON button (2); the ON light (5) will illuminate.
To start the program already set, press the START/PAUSE button (3) and keep it
pressed for a few seconds until the cycle start beep is heard. The light corresponding to
the first phase of the selected program will start to flash.
If it is necessary to open dishwasher door during the washing cycle, there
will be a 1-minute delay before the program can be resumed. After correctly
closing the door, the washing program will start again from where it was
interrupted. This operation may negatively affective the progress of the
washing cycle.
END OF CYCLE
At the end of the washing program the selector will be on one of the STOP markers,
depending on the program carried out. Switch off the dishwasher by pressing the
ON/OFF key (2).
TABLE FOR CERTIFICATION BODIES
Reference standard EN 50242
Reference program (*) Selector on P6
Load 12 place-settings
Type of detergent B
Amount of detergent 30 g
Rinse aid setting Depending on the model 3/4 or 4/6
EN 50242 STANDARD LOADS
LOWER BASKET UPPER BASKET WITH
METAL CUP RACK
UPPER BASKET WITH
PLASTIC CUP RACK
Depending on models, the cutlery basket may have removable grilles in which the
cutlery can be inserted to keep the items far enough apart and allow optimal water
passage.