Sears 485E - Manual (Page 7)

7
3. Attach a Pedal (31) to one of the Pedal Arms (12)
with three #8 x 3/4Ó Round Head Screws (16) as
shown.
Repeat this step to attach a Pedal to the other Pedal
Arm (not shown).
4. Make sure that there are Pedal Arm Bushings (42) in
the ends of both Pedal Arms (12).
Identify the Left Handlebar (8) (there is a decal on the
Left Handlebar for identification). Slide a Handlebar
Spacer (39) and one of the Pedal Arms (12) onto the
Left Handlebar as shown (these parts fit tightly; it may
be helpful to use the rubber mallet). Refer to the
PART IDENTIFICATION CHART on page 5 and iden-
tify the 3/4Ó Axle Caps (43). Tap a 3/4Ó Axle Cap onto
the Left Handlebar.
Repeat this step to attach the other Pedal Arm (12) to
the Right Handlebar (9).
5. Slide a Pedal Arm Spacer (41) and the left Pedal Arm
(12) onto the axle on the left Pulley Arm (34) (these
parts fit tightly; it may be helpful to use the rubber
mallet). Be careful not to confuse the left Pedal
Arm with the right Pedal Arm (not shown); look at
the position of the Left Handlebar (8) to identify
the left Pedal Arm.
Tap a 3/4Ó Axle Cap (43) onto the axle on the left
Pulley Arm (34).
Repeat this step to attach the right Pedal Arm (not
shown).
5
34
41
12
43
8
3
31
12
16
8
9
42
43
12
12
4
39