Sanyo DVD-SL25 - Manual (Page 34)

-E33-
SPECIFICATIONS
IMPORTANT INFORMATION
Because its products are subject to continuous improvement, SANYO reserves the right to modify product designs and specifications
without notice and without incurring any obligation.
MAINTENANCE
WARNING:
FOR YOUR PERSONAL SAFETY, BE SURE TO
DISCONNECT THE AC POWER CORD BEFORE
PROCEEDING WITH ANY MAINTENANCE OR CLEANING.
Cleaning the cabinet
Use a clean soft cloth moistened with plain lukewarm water and
wrung dry. Never use benzol, benzene or other strong chemical
cleaners since these could damage the finish of your unit. It is
important that no liquid reaches the inside of the unit.
Type:
DVD Video player
Signal format:
NTSC color
Laser:
Semiconductor laser, wavelength 650 nm/790 nm
Frequency range (digital audio):
4 Hz to 44 kHz (DVD fs: 96 kHz)
Signal to noise ratio:
More than 105 dB
Harmonic distortion (digital audio):
0.003 %
Wow and flutter:
Below measurable level
Outputs:
S-VIDEO OUT:
Y: 1.0 V
p-p
(75
Ω
)
C: 0.286 V
p-p
(75
Ω
)
COMPONENT VIDEO OUT:
Y: 1.0 V
p-p
(75
Ω
)
P
B
: 0.7 V
p-p
(75
Ω
)
P R : 0.7 V p-p (75
Ω
)
AUDIO OUT:
R: 2 V rms
L: 2 V rms
VIDEO OUT:
1.0 V
p-p
(75
Ω
)
DIGITAL OUT:
Optical
Power requirements:
AC 120 V, 60 Hz
Power consumption:
11 Watts
Dimensions (W x H x D):
Approx. 14.2" x 2.2" x 9.8" (360 x 55 x 250 mm)
Weight:
Approx. 4.3 lbs (1.95 kg)
SYMPTOM
The operation or display is not normal.
The remote control does not work properly.
SERVICING:
Should this product require service, refer to the SANYO AUDIO/DVD limited warranty.
If you do not have a convenient SANYO service station nearby, contact the SANYO dealer where you purchased the unit. Be sure to
give the model number and explain the problem. The dealer will advise you how to obtain service.
POSSIBLE CAUSE
The unit must be reset.
The batteries in the remote control are weak, or
installed incorrectly.
The remote control is not aimed at the remote
sensor window.
CORRECTIVE ACTION
1. Disconnect the power cord.
2. Reconnect the power cord.
3. Resume operation.
Check the battery polarity (+ or -).
Replace the batteries. (See page E4.)
Aim the remote control at the remote sensor window.
(See page E4.)