Sharp AFP80CX - Manual (Page 16)

16
Remove the battery compartment cover.
Insert the batteries in the compartment,
making sure the and polarities
are properly aligned.
Replace the cover.
HOW TO OPERATE
INSTALLING BATTERIES
Use two AA (R6) batteries.
Battery compart-
ment cover
NOTES:
• The battery life is approximately one year with normal use.
• When you replace the batteries, always use two new ones of the same type.
• If the remote control does not operate normally after replacing the batteries, take out
the batteries and replace them again after 30 seconds.
• If you will not be using the unit for a long time, remove the batteries from the remote
control.
HOW TO USE THE REMOTE CONTROL
Point the remote control towards the unit's receiver window and press the desired button.
A beep will sound when the unit receives the signal.
• Make sure no objects, such as curtains, block the receiver window.
• The remote control operates from up to 20 feet (6 meters) away.
• The beep will also sound when each pad on the control panel is touched.
CAUTION:
• Do not expose the receiver window to direct
sunlight. This can adversely affect its operation.
In such case, close the curtains to block the
sunlight.
• Use of a fluorescent lamp in the same room
may interfere with the transmission of the
signal.
• The unit may be affected by signals emitted
from the remote control of a television, VCR or
other equipment used in the same room.
• Do not leave the remote control exposed to
direct sunlight or near a heater. Protect the
remote control from moisture and shock which
can discolor or damage it.
2
1
3
USING THE REMOTE CONTROL