Sub-Zero Wine Storage 315W - Manual (Page 6)

Anti-Tip Bracket
An anti-tip bracket and hardware is provided with model
315W. Placement of the anti-tip bracket is critical to a
stable installation. The anti-tip bracket must be installed
securely.
Attach the anti-tip bracket to the top of the unit, opposite
the hinge side. The bracket offset flange should be facing
up with the two oblong holes in the front. Once the unit is
moved into position, open the door and secure the anti-tip
bracket to the countertop. Refer to illustration below.
To prevent the unit from tipping forward and provide a
stable installation, the unit must be secured in place
with the anti-tip bracket.
Model 315W Installation 6
ANTI-TIP BRACKET
Anti-tip bracket.
Unpack the Unit
Before moving the wine storage unit into position, make
sure the opening dimensions and electrical requirements
are complete and accurate.
IMPORTANT NOTE: The floor under the wine storage unit
must be at the same level as the surrounding finished floor
to allow for removal of the unit for servicing.
Use an appliance dolly to move the wine storage unit near
the installation opening. Position the dolly at the side of
the unit to prevent damage to finished surfaces. Remove
and discard all packing materials and tape.
IMPORTANT NOTE: Do not discard the kickplate, anti-tip
bracket and hardware. These items will be needed for the
installation.
The roller-assembly wine shelves should be removed to
reduce weight and prevent them from rolling. To remove,
pull the shelf out to its full extension, gently and evenly lift
up on both sides of the front of the shelf and remove.
Reverse the procedure to reinstall the shelf.
Before moving the wine storage unit into position,
protect any finished flooring with appropriate materials
and secure the door closed.