beautypg.com

Sub-Zero Wine Storage 315W User Manual

Page 10

background image

Model 315W Installation

10

Installation Checklist

To ensure a safe and proper installation, the following

checklist should be completed by the installer to ensure

that no part of the installation has been overlooked.

Has all packing material been removed?

Turn the unit on. Is it operating properly? If not, is the

unit plugged in? Is the control turned on?

Has the unit been secured in place with the anti-tip

bracket?

Is the unit level? Are all leveling legs making contact

with the floor?

Is the power cord plugged into a properly grounded

3-prong outlet, which has been installed in accordance

with all applicable electrical codes?

Is the kickplate installed properly?

Is the door panel attached securely and properly

aligned?

Is the door aligned for proper appearance and

operation?

Have any installation or service problems been noted

on the product registration card? Has the registration

card been mailed in?

Has the stainless steel door been inspected for any

imperfections? This is to be done by the dealer or

installer with the customer upon completion of the

installation. Stainless steel panels are covered by a

limited 60-day parts and labor warranty for cosmetic

defects.

Overlay Panel Installation

The model 315W glass door is made with a sealed,

double-wall tempered glass core. The drill must not

contact this core when drilling. Be sure the hole is

centered on the small groove in the front of the door

frame and the drill passes squarely through the frame.

If you are inexperienced with drilling, fasten the handle

from the rear of the door panel only.

IMPORTANT NOTE:

Install screws in all the mounting

holes in the door frame. The nature of the door panel with

a narrow outer rim and no connecting center member

requires the support provided by the glass door.

After the door panel installation is complete, apply the

cover patches or plugs provided over the holes on the

inside surface of the door.

The cover patches or plugs are part of the insulation

system on the door of the wine storage unit. Be sure to

cover all the holes in the door that were used.