Sanyo SC-B550 - Manual (Page 3)

Caution:
If the dust is packed tightly and
difficult to remove, lightly tap the
dust compartment.
If there is a reduction in suction power, turn off the vacuum cleaner, disconnect the hose and
proceed as follows:
1. To separate the dust compartment
from the vacuum cleaner, push the
clamp button as shown.
2. To remove the filter.
Caution:
Remove the filter slowly
to prevent the dust
from falling out.
3. Removing the dirt.
6. To reassemble the unit.
Insert the filter in the dust
compartment.
Then attach the dust
compartment section
to the motor section.
4. Slide the lever in the direction of
the arrows to remove the dust
by shaking.
5. Hold the clamp to open up the
pre-filter and empty the dirt out
of the filter.
DUST DISPOSAL /
Dust compartment
Clamp
Filter
Clamp button
Lever
Pre-filter