Sunbeam GR6400 - Manual (Page 4)

Toasting Sandwiches.
Hints For Best Results.
1. Always pre-heat your EasyClean Snack Maker
until the Ready Light Illuminates before use.
2. Always butter the outside of the bread. The
sandwich filling will be placed between the
unbuttered sides of the bread.
3. Place the buttered side of the bread onto the
cooking plate, then spoon the recommended
quantity of filling onto the bread.
4. Place the top slice of bread on top of the
filling with the buttered side facing upwards.
5. Gently close the lid until the two handles
close together. Click the latch into position to
keep the Snack Maker securely closed during
toasting. DO NOT FORCE THE LID CLOSED (if
the lid is difficult to close you may have too
much filling, or your bread slices may be too
thick).
Note: Ensure that the cord is kept well away
from the cooking plates when in use.
6. Allow the sandwiches to toast for
approximately 3 minutes, depending on the
bread, filling and personal taste. Your Snack
Maker toasts both sides of bread at the same
time and seals in the filling.
7. The cooking plates are coated with a durable
non-stick coating. Some fillings such as
cheese, may melt and cause the sandwich to
stick to the cook plates. To free the sandwich
use a plastic spatula or wooden spoon. Never
use a sharp object or metal as this will
damage the non-stick surface.
Note: The warm up and Ready lights are
thermostatically controlled and will cycle
during cooking to ensure that the correct
temperature is maintained.
1. Breads with a high sugar content (fruit loaf,
etc.) will toast more quickly than plain
sandwich breads.
2. Any type of bread can be used - white,
wholemeal, kibbled wheat or wholegrain.
For sweet snacks, sprinkle caster sugar over
the buttered sides of the bread.
3. Do not over fill your sandwiches. One third
of a cup of filling per sandwich is sufficient.
4. Be careful when biting into sandwiches
containing fillings such as cheese, tomato or
jam as they retain heat and can burn if eaten
too quickly.
Before using your EasyClean Snack Maker for
the first time, the non-stick cooking plates must
be seasoned. Turn the power ON and pre-heat
your EasyClean Snack Maker until the Ready
Light illuminates.
Wipe a small amount of butter onto the plates,
rub lightly and wipe away any excess.
NOTE: When using your Sunbeam Easy Clean
Snack Maker for the first time you may notice a
fine smoke haze being emitted from the unit.
This is normal. It is due to the initial heating of
internal components.
1. Insert the 3 pin plug into 230 or 240 volt
outlet.
2. Turn the power ON and preheat your
EasyClean Snack Maker until the Ready light
illuminates.
Before using your EasyClean Snack Maker.