Sierra 5391-02 - Manual (Page 15)

T12017-Sentry_LANServer_Users_Manual Page 15 of 59
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-2269 Toll_Free: 888-509-1970 email: [email protected]
Problem The sensor reports that the analog value is invalid.
Warning A concentration level above the warning set point. This also activates the
warning relay on the Sentry.
Alarm A concentration level above the alarm set point. This also activates the alarm
relay on the Sentry.
Normal None of the above.
If any sensor is reporting a
warning AND no sensor in the
zone is in alarm then the zone
will be displayed in orange.
If any sensor in the zone is in
alarm then the zone displays red
If a sensor in the zone is
reporting a problem and there
are no sensors in the same
zone reporting a warning or an
alarm then the zone displays
grey
If all sensors in the
zone are in a normal
condition
then the
zone displays green.
If the zone buttons are white then the
problem being indicated does not relate
to the state of the Sensor but relates to
the transfer of new data to the web page.
Refer to Appendix 1.