Sharp VL-Z7U - Manual (Page 27)

13
Preparation
Installing the Battery to
Remote Control
The supplied CR 2025 type lithium
battery is used to power the remote
control unit.
1
Hold the remote control facing down,
and pull out the battery holder while
pressing the tab toward the center.
2
Insert the larger lithium battery into
the battery holder with the H side of
the battery facing the m side of the
holder.
3
Insert the battery holder back into
position.
Notes on the Use of the Lithium
battery
• Do not short-circuit, recharge, disassemble,
or heat the lithium battery.
• Should the lithium battery leak, wipe the
battery compartment clean, and then insert a
new battery.
• The lithium batteries will last about one year
under normal usage.
CAUTION The battery used in this
device may present a risk of fire of
chemical burn if mistreated. Do not
recharge, disassemble, heat above
212°F (100°C) , or incinerate. Replace
battery with the type CR1216 for the
camcorder and the type CR2025 for the
remote control unit of Toshiba Battery
Co., Ltd. only. Use of another battery
may present a risk of fire or explosion.
Dispose of used battery promptly. Keep
away from children. Do not disassemble
and do not dispose of in fire.
“m” side
H side, CR 2025 type
lithium battery
Tab