Sonic Blue 4500 User Manual
Replaytv 4500
Table of contents
Document Outline
- ReplayTV 4500
- User’s Guide
- Table of Contents
- Chapter 1 Getting Started
- :: Welcome
- :: Remote Control Overview
- 1 ReplayTV (POWER)
- 2 TV (POWER)
- 3 LIGHT
- 4 BYPASS
- 5 INPUT
- 6 TV/DVR
- 7
- 8 CH Y/B
- 9 TV VOL +/-
- 10 REPLAY ZONES
- 11 DISPLAY
- 12 MUTE
- 13 0-9
- 14 JUMP
- 15 ENTER
- 16 ARROW (NAVIGATION) BUTTONS
- 17 SELECT
- 18 CHANNEL GUIDE
- 19 REPLAY GUIDE
- 20 MENU
- 21 EXIT
- 22 PAGE Y/B
- 23 REC
- 24 RETURN TO LIVE
- 25 INSTANT REPLAY
- 26 QUICKSKIP
- 27 REW
- 28 PLAY/SLOW
- 29 FF
- 30 PAUSE
- 31 STOP
- :: Front Panel Overview
- :: Rear Panel Overview
- :: About Service Activation
- Chapter 2 Connections
- :: Basic Connections
- :: Planning your Setup
- Incorporating ReplayTV into your Entertainment System
- Checking your Satellite Receiver
- Connecting ReplayTV to an A/V Receiver
- Connecting ReplayTV to a VCR
- Connecting a Video Camera or VCR to ReplayTV
- Connecting Cable Box and Satellite Receiver Controllers
- Connecting the Serial Cable
- Connecting the IR Blaster
- Locate the infrared detector on your cable box or satellite receiver
- 1 Refer to the owner’s manual of your cable box or satellite receiver. It may be shown there.
- 2 Look for an area of dark, nearly opaque plastic on the front of the unit. If you find this area...
- 3 Shine a flashlight through the dark plastic area on the front of the unit. If you see the infra...
- 4 Using the remote control for your cable box or satellite receiver, turn the power on and off. D...
- 5 With the remote control in one hand, place the other hand over one section of the front of the ...
- 6 Try to turn the power on and off. If you succeed, your hand is not covering the infrared detector.
- 7 Move your hand to a different place on the front of the unit and repeat steps 5 and 6. Keep rep...
- Connect and affix the IR blaster
- 1 Plug the IR blaster into the IR BLASTER connector on the back of ReplayTV.
- Completing the On-screen Setup
- :: Home Network Connections
- Connecting ReplayTV to an Existing Network
- 1 If you are connecting ReplayTV to a broadband network, plug the supplied Ethernet cable into th...
- Connecting ReplayTV to a Cable Modem
- Connecting to a router
- 1 Use a recommended router that your ISP supports and connect it directly to your cable modem. (S...
- 1 Verify that there is no special software or log on required for Internet access.
- 2 Verify that no settings other than the IP address, Subnet Mask, Gateway address, and DNS Server...
- 3 Check to see if your ISP requires the MAC address of devices like ReplayTV for Internet connect...
- 4 Refer to “Connecting ReplayTV to an Existing Network” on page12 to complete the setup.
- Connecting directly to a cable modem
- 1 Verify that there is no special software or log on required for Internet access.
- Router Setup
- 1 If you are not manually specifying the IP address on ReplayTV, verify that DHCP is enabled on y...
- 2 Verify that DNS is enabled on your router and the proper DNS entries have been added. These wou...
- 3 Verify that the router does not block ReplayTV’s IP address. This setting can normally be found...
- 4 Verify that TCP ports 53 (DNS), 123 (NTP), 80 (HTTP) are open. Your router documentation should...
- 5 When you first go to the ReplayTV Internet Address Book, you are asked to open a port number on...
- Configuring Ports for Sending Recordings
- 1 If you are not manually specifying the IP address on ReplayTV, verify that DHCP is enabled on y...
- Using ReplayTV with Firewall Software
- Entering Networking Information Manually on ReplayTV
- Determining the ReplayTV IP Address
- Determining the ReplayTV MAC (Media Access Control) Address
- Finding the Router IP Address
- Finding your Computer’s Network Information
- Connecting ReplayTV to an Existing Network
- Chapter 3 Setup
- :: About Menu Navigation
- :: Main Menu
- :: Setup Menu
- Chapter 4 Basic Operations
- :: Basic Operations
- :: Controlling Live Television
- :: Accessing the Channel Guide
- :: Recording Shows
- :: Find Shows
- 1 Press MENU on the ReplayTV remote control.
- 2 Select Find Shows.
- 3 Enter one or more keywords.
- 4 Select Done.
- 5 Set Find Shows options.
- 6 Select Done.
- 7 Select Create the “Keyword(s)” Theme Channel. You can also highlight an individual show and pre...
- 8 Set Record Options. See “Setting Record Options” on page35 for more information.
- 9 Select Done. Your show will be recorded at the scheduled time.
- 1 Press MENU on the ReplayTV remote control.
- :: Replay Zones
- :: Using Manual Record
- Recording by date, time and channel
- Recording and sharing home videos from a video camera or VCR
- 1 Select Manual Record from the Main Menu and choose Single Recording.
- 2 Set the date and time you want the recording to begin. Continue to the screen where you choose ...
- 3 Choose the input source to which the video camera or VCR is connected. See “Connecting a Video ...
- 4 Turn on your video camera or VCR before the scheduled recording time you set up.
- 5 ReplayTV will begin recording at the scheduled time you set up. Once the recording is completed...
- 1 Select Manual Record from the Main Menu and choose Single Recording.
- Changing the Default Record Options
- Cancelling a Recording
- Resolving Conflicting Recordings
- Replay Channels
- Recording Tips
- :: Using the Replay Guide
- Chapter 5 Advanced Features
- :: Watching Shows Recorded on other ReplayTVs
- :: Sending Recordings to other ReplayTVs
- :: COMMERCIAL ADVANCE
- :: Screen Saver and Pause Screen
- :: Remote Control Shortcuts
- Chapter 6 Help
- :: Troubleshooting
- :: Glossary
- :: Technical Specifications
- :: Limited Warranty and Software License
- :: Privacy Policy
- :: Safety
- Important Safety Instructions
- 1 Read Instructions
- 2 Retain Instructions
- 3 Heed Warnings
- 4 Follow Instructions
- 5 Cleaning
- 6 Attachments
- 7 Water and Moisture
- 8 Accessories
- 9 Ventilation
- 10 Power Sources
- 11 Grounding or Polarization
- 12 Power–Cord Protection
- 13 Protective Attachment Plug
- 14 Outdoor Antenna Grounding
- 15 Lightning
- 16 Power Lines
- 17 Overloading
- 18 Object and Liquid Entry
- 19 Servicing
- 20 Damage Requiring Service
- 21 Replacement Parts
- 22 Safety Check
- 23 Wall or Ceiling Mounting
- 24 Heat
- Safety/Regulatory Information
- Important Safety Instructions
- :: FCC and Industry Canada Compliance
- FCC Registration and Requirements
- FCC Rules, Part 15
- FCC Rules, Part 68
- 1 This equipment complies with FCC Rules, Part 68. On this equipment is a label which contains, a...
- 2 The Federal Communications Commission (FCC) has established Rules which permit this device to b...
- 3 If this device is malfunctioning, it may also be causing harm to the telephone network; this de...
- 4 The telephone company may make changes in its technical operation and procedures; if such chang...
- 5 If the telephone company requests information on what equipment is connected to their lines, in...
- 1 This equipment complies with FCC Rules, Part 68. On this equipment is a label which contains, a...
- Index