Shindaiwa LE254 - Manual (Page 13)

13
10- 15 Hour Maintenance
spark plug gap--all models
Clean the spark
plug and check
the gap at the
electrode.
CAUTION!
Before removing the spark plug,
clean the area around the plug to
prevent dirt and debris from getting
into the engine’s internal parts.
Remove and clean or replace the
spark plug.
■
Clean the spark plug. Adjust elec-
trode gap according to the values
listed in the ”Specifications” section.
If the spark plug must be replaced,
use only the type recommended in
”Specifications” or equivalent resis-
tor type spark plug of the correct heat
range.
0.6 mm
(0.024 in.)
Unscrew
Fasteners
1. Remove the air cleaner cover by
loosening the thumbscrews and
lifting.
2. Remove and inspect the pre-filter.
If the pre-filter is torn or otherwise
damaged, replace it with a new
one.
3. Clean the pre-filter with soap and
water. Let dry before reinstalling.
4. Inspect the air filter element. If the
element is damaged or distorted,
replace it with a new one.
5. Tap filter gently on a hard surface to
dislodge debris from element or use
compressed air from the inside to blow
debris out and away from the air filter
element.
6. Install the air filter element, pre-filter
and cover in the reverse order of
removal.
Air Filter
Element
Pre-Filter
IMPORTANT!
Direct the air stream at the inside face
of the filter only!
CAUTION!
Never operate the unit if the air
cleaner assembly is damaged or
missing!
10 Hour Maintenance
Maintenance (continued)