Shark VAC-THEN-STEAM MV2010WM - Manual (Page 9)

12 TOLL FREE: 1-800-798-7398 13 www.sharkclean.com
English Maintaining Your Vac-Then-Steam
CARE OF YOUR MICRO-FIBER
CLEANING PAD
1 Wash pads in warm water. Wash
separately from other laundry. Only
use liquid detergent. (no powder
detergent) Do not use fabric
softeners. Line dry or dry on a low
dryer setting.
2 If there are loose threads on the pad
carefully cut the thread with scissors.
Do not pull on them or cut at the
base.
POST-MOTOR FILTER
1 Twist the logo knob on the post-
motor cover counter-clockwise to
release cover.
2 Use both hands to grip cover on both
sides and pull away.
Gently peel Filter from cover. Rinse
filter and let air-dry 24 hours.
3 Replace filter inside the cover,so that
it fits within the cover frame. Snap
cover into place.
Twist logo knob clockwise to
secure cover.
CARE OF YOUR FOAM FILTER
1 Turn off the vacuum. Pull out the
dust cup. See page 7 for instructions.
Pull the filter frame out from the
top and remove the foam filter
from inside.
2 Rinse the filter in lukewarm water
and squeeze the water out. Let it air
dry for 24 hours.
When the foam filter is completely
dry, reinsert it into the filter frame
and put the frame back into the filter
compartment.
NOTE: Replace the Foam Filter every
3 months to maintain the best
performance of your vacuum.
NOTE: Replace the Post-Motor filter
every year to maintain the best
performance of your vacuum.
DO NOT use a hair dryer or any other
forced hot air to dry the filter.
ORDERING REPLACEMENT PARTS
To order additional parts and
accessories, visit us at
www.sharkclean.com
or call 1-800-798-7398.
2
2
2
1
1
3
1