Soundstream Technologies G7170 - Manual (Page 4)

Crossover Installation
1. The crossover should be mounted in a dry, moisture free location. Never
install the crossover in the door where it can be damaged by water and
moisture. The crossover can be installed in the door panel as long as there
is an undamaged vapor barrier.
2. There are three sets of connections on the crossover. The Input terminals
should be connected to the source of the signal (radio or amplifier). The
woofer terminals should be connected to the midbass driver. The tweeter
terminals should be connected to the tweeter. The tweeter volume can be
set at -3dB, 0dB and +3dB. Ensure that the negative polarity wire of the
tweeter is the one used for setting the tweeter volume level. Make sure
that the polarity on all connections is correct.
L1
L2
C1
C2 C3
R1 R2 R3 R4
+3dB 0dB -3dB TW+ WF- WF+ PUT- +IN