Soundstream Technologies G7170 - Manual (Page 2)

Congratulations on your purchase of Soundstream’s Picasso component
speaker system. The Picasso component system represents Soundstream’s
design approach to creating musical reproduction with the richness and
clarity while maintaining cost effectiveness. Only the best materials and
production techniques were used to create an exceptional line of
component system speakers. We hope you will enjoy your Picasso
components for many years to come.
Features:
• Stamped steel basket with brushed finish
• Woven glass fiber spruce pulp laminate cone
• NBR rubber surround
• Precision machined and matched motor assembly
• Custom embossed protective magnet boot
• 1” Copper voice coil on aluminum former with reinforced neck joint
• 1” Teflon silk dome tweeter with resin coating
• DC tweeter protection circuit
• 12dB low pass with presence switch
• 18dB high pass with 3-way sensitivity switch
Tweeter Installation
Mounting hardware contained in the packaging will allow a surface or flush
mount installation. The tweeter should be mounted on the same plane and
within 6 inches of the mid-bass driver to avoid any phase shift. Also, as the
frequencies that the tweeter reproduces are very directional, avoid placing
the tweeter in a position that will be obstructed either by objects in the vehicle
or by passengers. As with the mid-bass driver, if a factory tweeter location is
available, it is recommended that it be used. If it is necessary to cut a hole to
mount the tweeter, then be careful to find a location that will have enough
depth and will not interfere with any moving parts in the vehicle.
Flush Mounting: When flush mounting the tweeter, it will be necessary to use
the tweeter cup, rear wing bracket. Mount the rear wing bracket to the
mounting cup with the supplied screw, insert the tweeter into the cup and
secure with the same screw used to mount the wing bracket. Push the tweeter
assembly into the rear of the vehicle’s tweeter opening and fasten assembly
to the opening by twisting on the flush mount ring from the front.