beautypg.com

Operation, Engine speed, Ground speed selector – Simplicity 1693426 755E User Manual

Page 14: Deflector, Scraper bar & skid shoes

background image

ENGINE SPEED

For overall best performance, run the snowthrower at full
engine operating speed. Use the engine Throttle Lever
(See Figure 8) to set the engine speed. Slide the Throttle
Lever UP to increase engine speed, and DOWN to
reduce speed.

GROUND SPEED SELECTOR

Use the Speed Selector (A, Figure 7) to control the drive
speed of the snowthrower. There are five forward speeds
and two reverse speeds.

Use the lower speeds to blow deep or wet snow. Use the
higher speeds to blow light snow or to drive the snow-
thrower without blowing snow.

To change speeds, first release the traction Drive Control
lever (B, Figure 7), then move the Speed Selector to the
desired speed setting. Fully press the traction Drive
Control lever to resume operation.

DEFLECTOR

The distance of the discharged snow is mainly controlled
by the position of the deflector (Figure 9). (Engine speed
also affects distance of discharge.)

The more the deflector is tilted UP, the farther snow will
be thrown. Loosen the deflector knob, tilt the deflector
UP or DOWN, and then retighten the knob when the
desired angle has been chosen.

SCRAPER BAR & SKID SHOES

On smooth surfaces such as concrete or asphalt, the
scraper bar should scrape the surface. On surfaces such
as gravel, the scraper bar should be high enough so that
it will not pick up gravel or debris.

The height of the scraper bar is controlled by raising or
lowering the Skid Shoes (See Figure 10).

1. To raise the scraper bar height, rest the scraper bar

on a strip of wood equal in thickness to the desired
height.

2. Make sure the scraper bar is parallel to the ground

surface.

3. Loosen the skid shoe nuts and let the skid shoes

drop to the surface.

4. Tighten the nuts, making sure the Skid Shoes are

adjusted equally and are parallel to the surface.

5. To lower the height of the scraper bar, raise the Skid

Shoes.

6. If the scraper bar becomes worn, it can be replaced

by removing the hardware attaching it to the
snowthrower.

10

Operation

Figure 8.

Engine Speed Selection

Figure 10. Skid Shoe Adjustment

Scraper

Bar

Skid Shoe

Figure 9.

Chute Deflector Adjustment

Chute

Deflector Knob

Chute

Deflector

Throttle
Lever

Skid Shoe

Nuts

This manual is related to the following products: