Woodstock MICRO MILL M1036 - Manual (Page 26)

-24-
M1036 Micro Mill
SE
RV
IC
E
After some period of time, the carbon brushes on the
DC motor will need to be replaced. Always replace the
brushes in pairs.
To replace the motor brushes, do these steps:
1. UNPLUG THE MICRO MILL!
2. Remove the lower motor cover (see Figure 31) to
expose the motor.
3. Unscrew the cap from the motor housing (see Figure
32).
4. Remove the spring and carbon brush, and replace
with a new spring and carbon brush.
5. Screw the cap back into the motor housing.
Replacing Motor Brushes
Figure 32. Carbon brush removal.
Carbon Brush
Cap
Figure 31. Lower motor cover.
Figure 33. Fuse replacement.
A fuse is located in the switch housing near the RPM dial.
To replace the fuse, do these steps:
1. Loosen the fuse cap.
2. Remove and replace the fuse from the fuse cradle
(see Figure 33).
3. Replace the fuse cap.
Fuse Replacement